Ratoc Systems CBFW3 Guide de l'utilisateur télécharger pdf (Page 21)

2-3.DVCAM Installation

This section describes how to connect a DVCAM and install the DV driver.

Connect the CBFW3 and a DVCAM using the IEEE1394 cable as shown below.

And turn on the DVCAM power switch. You can connect the DVCAM without turning off the PC

or DVCAM.

4pin-6pin IEEE1394 cable which

comes with this package

When your Windows version is Windows 98 SE(Second Edition), go to the Chapter 2-3-1.

When your Windows version is Windows 2000, go to the Chapter 2-3-2.

When your Windows version is Windows Me(Millennium Edition), go to the Chapter 2-3-1.

NOTE

Refer to the manual that accompanied your DVCAM for the location of DV connector.

DV connector

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 89 90

Pas de commentaire

Ratoc Systems CBFW3 Guide de l'utilisateur Page 21